 |
LegendaryFire
Moderator
Joined: Jul 20, 2009
Posts: 840
Location: Canada
XP: 55,922
|
| |
|
Posted: Sat May 29, 2010 4:48 pm
Post subject: Re: zephyr jtag help |
 |
| |
| cheatmaster5 wrote: |
I have jtagged lots of xenon but this is my first zephyr and I need a little help.
I have already dumped the nand and got two matching copies of it. The cb is 4558 so it is exploitable.
I have already wrote xbr to it but I am having a hard time with the jtag connects. I have the one that goes to the RF board hooked but fine but I am having a hard time with the other one. Whats the best way to solder it? is there a connection under the board that work or any alternative points? Is there a video of some one doing a zephyr?
the point circled in red is the one i am having a hard time with.
Thanks in advance |
If there is allready solder in it, mix the solder with your solder. Make sure to tin your wire, heat up the wire and it should then just fall down into the hole. If you have any more questions feel free to ask! Good Luck.
EDIT:
If your having trouble getting the pin/wire to stay stable, just melt the solder in the motherboard (if there is any) a few times, and then once it has cooled down, touch the wire to the top of the solder and then just add a small amount of your own solder to the solder allready in the motherboard. But remember, it is always better to have it soldered perfectly.
_________________________________________________________
You can contact me at: LegendaryFire -at- 360-HQ.com
|
|
|
|
HQ Network: 15,619 | 
Guests: 4288 |
Members: 0
